How to Hook Up a Remote Wire to the Sony Xplod | It Still Works How to Hook Up a Remote Wire to the Sony Xplod | It Still Works

How to hook up amp turn on wire, video of the day

Cut the wire to length with the cable cutters and insert the wire into the ground lug bus.

dating october 22 holiday

Do I need to keep the factory sub installed and wired up too? Sometimes you really only need to use two audio signals.

campsite electrical hookup

Connect the other pair of cables from the output channels on the back of the equalizer to the left and right input channels on the amplifier. The control has nothing to do with it. If you do not have space in your dash you will need an under-dash mounting kit.

dating sarreguemines pottery markings

September 24, at 3: Tighten the two cable clamp screws until the clamp is snug. If your receiver does not have a wiring diagram to show which wires are switched power cables, then you should use a digital multimeter to identify the correct cable.

love dating sim 2 hacked

Sy July 8, at 9: It could be a separate terminal, or it could be a jack located on a larger wiring harness. Pull enough wire through the clamp to leave a 3-foot tail. You got more balls than i do: Is there any amp that will work with my stock head unit September 24, at 3: Some have that option.

absolute age dating and relative age dating question

The remote turn-on wire is usually connected to a dedicated wire from the radio specifically intended for this purpose, and on some older radios you can use the power antenna signal wire, but on most newer units, this wire has no power when using any function other than the tuner.